30W Mopa Fiber Laser Marking Machine Mark Colors On Stainless Steel

Through this video, you can see mopa fiber laser marking machine mark colors on stainless steel. Laser power 30W 50W optional. XDLASER offer whole life technical support. 

For marking colors, we need mopa fiber laser source. If you do not need color, normal fiber laser source is ok.

The Steps For Using Fiber Laser Marking Machine:

Check the waterway and circuit before starting. The startup sequence is as follows:

① Turn on the incoming power and turn on the key switch. At this time, the ventilation and refrigeration system of the machine is powered on, and the ammeter shows about 7a;

② Wait for 5-10 seconds, press the trigger button on the external control panel, and the ammeter displays zero. After 3-5 seconds, the krypton lamp lights up, and the ammeter displays 7a（ Refer to the operation manual of laser power supply);

③ Turn on the power supply of the galvanometer;

④ Turn on the computer and call out the required marking file;

⑤ Adjust the laser power supply to the working current (10 ~ 18a) to start marking;

At the end of marking, turn off the power of each component in reverse order as above:

① Adjust the working current of laser power supply to the minimum (about 7a);

② Turn off the computer;

③ Turn off the power of the galvanometer;

④ Press the stop button;

⑤ Turn off the key switch;

⑥ Disconnect the incoming power supply.

Welcome to contact XDLASER for details:

info@xdlasers.com

Whatsapp: +86-15169026664

Skype/wechat: juliali01