Publish Time: 2021-03-11 Origin: XD laser
Laser cutting machine has different working tables. The tables are honeycomb table,plate table,strip table,auto feeding table and so on.
1. Feed the materials in roll to the machine table automatically.
The auto feeding table of co2 laser cutting machine has its own motors to control the feeding work. When you press the button on machine or in the software,the motor works and move the auto feeding table. In this case, the leather,cloth or fabric mateiral in roll goes to the table. Once the cutting work is finished, the machine feed material again untill the whole roll is well cutted.
2. Unloading the material already cut to a bag
When the table is moving, the material already cut can go to a bag automatically.
1. Observe the safety operation regulations of general cutting machine. Start the laser in strict accordance with the laser starting procedure. 2. Operators must be trained, familiar with equipment structure and performance, and master relevant knowledge of operating system.
3. Wear labor protection articles as required, and wear qualified protective glasses near the laser beam.
4. Do not process a material before it is clear whether it can be irradiated or heated by laser, so as to avoid the potential danger of smoke and vapor.
5. When the equipment is started, the operator shall not leave the post or entrust someone to be in charge without authorization. If it is really necessary to leave, stop the machine or cut off the power switch.
6. Put the fire extinguisher in an accessible place; Turn off the laser or shutter when not processing; Do not place paper, cloth or other inflammables near unprotected laser beams.
7. In case of any abnormality during processing, stop the machine immediately, eliminate the fault in time or report to the supervisor.
8. Keep the laser, bed and surrounding site clean, orderly and free of oil stain, and stack workpieces, plates and wastes according to regulations.
9. After startup, manually start the machine tool at low speed in X and Y directions to check whether there are abnormalities.
10. After inputting the new workpiece program, it shall be commissioned first and its operation shall be checked.
11. During operation, pay attention to the operation of the machine tool to avoid accidents caused by the cutting machine out of the effective travel range or the collision between the two machines.
Auto feeding co2 laser cutting machine is widely used in sofa producing,bag producing,car inside things producing and so on.
XDLASER has auto feeding laser cutting machine with optional working sizes and laser powers. Welcome you to contact us for details.