Publish Time: 2021-04-23 Origin: XDLASER
Fiber metal laser cutter is the most popular equipment for cutting stainless steel and carbon steel. It is because of the higher precision and fast cutting speed than traditional equipment. Fiber laser source is the core equipment of fiber metal laser cutter.In case laser source failure,it has a great impact on the use of the whole machine. One of the main reasons for the failure of fiber laser power supply is the internal condensation of the laser. So, it is very important to operate the machine,power on and offer the fiber laser cutter by following the steps. By following the steps,you can use your machine much longer, maybe more than 10 years.
The power on steps of fiber laser cutter:
1) Confirm there are nothing easy to get fire around the whole machine
2) Power on the core switch and other switches.
3) Open the stabilizer and check whether it can work fine. Stabilizer is an optional part of the machine. If your voltage is stable, you do not need it. If you voltage is not stable, you need to buy one stabilizer.You can buy from laser machine manufacturer of buy it on the market, both ok.
4) Open the water chiller. Before you open the water chiller, please be sure you already put enough clean water into it.
5) Open the fiber laser source. After some mins, open laser and let the laser source dry for 30 mins.
6) Open the air compressor or nitrogen or oxygen to feed the laser head with gas.
7) Open the computer with machine software installed. The controller begin to work. After the control system open, the laser head go to zero point
8) After the water chiller temperature is ok, open laser and check everything fine or not.
9) Open the air exhaust or filter and check they are normal. Now, the machine is ready to cut metal.
The power offer steps of fiber laser cutter
The power offer steps of fiber laser cutter is almost the converse of power on. Please 1st power offer the part which you power on last.
1. Power offer the exhaust.
2. Power offer laser,machine head back to original point.
3. Power offer control system. Power off the whole machine.
4. Power offer the water chiller.
5. Power off the air compressor and so on.
6. Power offer the stabilizer.
7. Power offer the core switch.
Please be sure to follow the above steps and avoid any problem of the laser source. We hope you can use your laser cutter as long as possible.
For details, welcome you to contact XDLASER.
Whatsapp: +86-15169026664